View Single Post
Old July 26, 2011, 08:04 AM   #19
hornetguy
Senior Member
 
Join Date: January 14, 2011
Location: on the north side of DFW
Posts: 803
now that setup is just fascinating. I've been toying with the idea of building a casting setup that will bring the mold up to the optimum temp so that each cast fills out the same. I had hoped to minimize the number of casts needed to bring the mold up to temp.
Can you describe how yours works?
hornetguy is offline  
 
Page generated in 0.04276 seconds with 7 queries