View Single Post
Old July 25, 2011, 04:01 PM   #2
hornetguy
Senior Member
 
Join Date: January 14, 2011
Location: on the north side of DFW
Posts: 802
I have always used electric. If you prefer ladle casting, you can find some really nice pots that will allow that.
I imagine it is easier to control the temp with an electric heat source, rather than gas.
Using a gas (turkey fryer) source to melt/smelt down large quantities of lead is probably the best choice, but for casting, I'd go electric.

edit: Look at the Lee brand 20# capacity... best value.
hornetguy is offline  
 
Page generated in 0.05668 seconds with 7 queries