View Single Post
Old July 22, 2011, 11:41 AM   #404
Fish_Scientist
Member
 
Join Date: August 22, 2009
Location: SW Montana
Posts: 90
Because of a lack of room in my house, I went with the "small bench built on a Black and Decker Workmate" route. It's not much, but it's enough for me to reload. Eventually (soon, hopefully!) we'll be in a bigger place where I can actually have a shop or garage...

Made with 3/4" pine plywood all around, fastened with 1/4" dowels. Before sanding and urethane:



After a few rounds of reloading; the high walls on the shelf keeps stuff from falling off and provides a good place for me to keep my manuals.



Fish
Fish_Scientist is offline  
 
Page generated in 0.04068 seconds with 7 queries