View Single Post
Old July 9, 2011, 11:48 AM   #14
jmr40
Senior Member
 
Join Date: June 15, 2008
Location: Georgia
Posts: 6,176
Use a HACKSAW, not a pipe cutter. I've done several. Cut right through the rib closest to the final length you want. Use a file and square to square up the end and touch up with cold blue. This is a 5 minute job from start to finish. I've used fiber optic sights that fit on the rib to replace the front sight. The barrels work and look great afterward. If you decide to have the barrel re-threaded for choke tubes later that is an option as well.
jmr40 is offline  
 
Page generated in 0.04571 seconds with 7 queries