View Single Post
Old June 27, 2011, 06:41 PM   #51
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
Paert of getting the MEC Jr. to be consistent - whether with bushings or a charge bar is to get into a certain rhythm; I push the bar hard to each side - it helps settle powder and shot into the openings, it helps it there is a small piece of shot or some flakes from gumming it up, and it makes sure I move the bar completely to each side.

Once you figure out what works best for you, you'll find that your drops are consistent in both shot and powder.

I can get my Jr. to drop even better than my progressive because I nudge it that way.

When I push the bar from side to side, I do not use the lever in the middle, but I place finger tip on the end of the UCB - it seems to fit in the recess on the dial just right- I can then flick it as mentioned
oneounceload is offline  
 
Page generated in 0.04643 seconds with 7 queries