View Single Post
Old June 27, 2011, 01:06 PM   #2
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 719
Here is a thread on Squaring the die.

http://thefiringline.com/forums/show...ght=square+die

You will also find out that each manufacturer uses a different bench height on the shellholder which will change how much the shoulders get set back. Some will give you too much setback and others may not give you enough to chamber the round.
PA-Joe is offline  
 
Page generated in 0.04683 seconds with 7 queries