View Single Post
Old June 23, 2011, 08:07 PM   #14
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 3,065
What powder/bullet loads are you running?
(Minimum loads per the manuals usually mean anywhere from low 30's to mid 40s Kpsi -- low/moderate pressures)

Combine that w/ a case that's sized too short and you have protruding primers when they don't stretch (as w/ sizing lube left on case), and flattened primers when they do (dry case locks into chamber walls up front and the rear then stretches to meet the bolt).
mehavey is offline  
 
Page generated in 0.05540 seconds with 7 queries