View Single Post
Old June 21, 2011, 05:27 PM   #11
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,581
Mr.Guffy , neck dies are Cartridge specific , the die you got with your 06 die set is for the 06 only . If the Case has been fired in his Rifle . Then they are fire formed to his Chamber and only need neck sizing . I would suggest that you do some neck sizing before you Pooh Pooh the practice ! Neck sizing absolutely extends case life , especially in Cartridges under .30 Cal. . Once you get to .35 Cal. it becomes a Moot point ! If you are going to use Neck sized Brass for hunting , run them through the chamber to insure they will feed and chamber !
oneoldsap is offline  
 
Page generated in 0.04686 seconds with 7 queries