View Single Post
Old June 21, 2011, 07:00 AM   #3
PawPaw
Senior Member
 
Join Date: December 24, 2010
Location: Central Louisiana
Posts: 3,102
Yup, you can use the FL die to neck size, but you may have to "fiddle" with it a little bit. What you want is for the brass to go into the die far enough that the neck is sized, but not so far as to set the shoulder back. If you can find that spot where the die just kisses the shoulder, that's where you want to be.
__________________
Dennis Dezendorf

http://pawpawshouse.blogspot.com
PawPaw is offline  
 
Page generated in 0.04869 seconds with 7 queries