View Single Post
Old June 20, 2011, 08:12 PM   #1
TrooperLX
Junior Member
 
Join Date: June 20, 2011
Posts: 2
Excam Model GT 25SC

I have completely stripped, properly cleaned this 25SC with CLP and an AP Brush, and am now in the assembly process. I made my own complete diagram and I thought I was very detailed, but I left out exactly how the trigger/tension spring and magazine latch with spring go back together. I am basically at a hault. I have tried a few different ways and the problem that I am having is that the spring that goes in the trigger keeps shooting out before I can get the pin attached. I believe it is very similar to the GT 27 from the searches that I have done already. Tomorrow I am going to see a gun smith to see if he knows the order and way that the trigger assembly has to be put back together. I think I might have taken too much apart, but it needed to be cleaned thoroughly. I would like to know if anyone has any advice for this pistol. Any help would be appreciated. Thanks for the time.
TrooperLX is offline  
 
Page generated in 0.04698 seconds with 7 queries