View Single Post
Old June 16, 2011, 11:28 PM   #9
Ideal Tool
Junior member
 
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
Hello, Shootin Chef. Your lucky it moves ok. You could disassemble everything & use either Naval Jelly like dahermit said. You could clamp round parts in padded vise & use wetor dry paper in a "shoe shine" fashon to polish up..there will probably be pitting with that amount of rust. You could take it to a shop & have it bead blasted with fine glass "balls" this will give metal a fine matt finish & pits will be less noticiable. If you really are ambitious, plug up all holes in casting, & have it sandblasted & repaint with a crinkle type automotive paint..I did this with an old C-H 0 frame & let it set in hot sun after painting..turned out like new. Good luck!
Ideal Tool is offline  
 
Page generated in 0.04127 seconds with 7 queries