View Single Post
Old June 16, 2011, 11:17 PM   #7
Shootin Chef
Senior Member
 
Join Date: January 30, 2011
Location: Columbia, SC
Posts: 121
Yes, it moves up and down and isn't frozen, but I have no idea how far up it's supposed to go. Where it sits in the picture, it goes up maybe another half an inch? Is it supposed to go up further? Should I remove the rust on the outside/underside/handle and try to remove the rust on the ram?

What about the primer device? Is it to corroded? It doesn't seem to seat very well in the metal piece at the back of the press unless I move it in there.
Shootin Chef is offline  
 
Page generated in 0.03398 seconds with 7 queries