View Single Post
Old June 16, 2011, 10:32 PM   #5
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 4,274
It is an RCBS Jr. press. You have a couple of RCBS primer tubes for the priming device. Does the ram on the press move when you work the handle? If so, it is not frozen with rust. There are a few different ways to get the rust off if you can get the ram out of the press. If you are very lucky the part of the ram that is covered by the press is not covered with rust. You can use Navel Jelly to remove the rust on the ram. Or, if you know how, and have a large plastic bucket, you can use electrolysis to remove the rust from the ram and other steel parts.
dahermit is online now  
 
Page generated in 0.04957 seconds with 7 queries