View Single Post
Old June 5, 2011, 02:08 PM   #1
lt dan
Senior Member
 
Join Date: March 4, 2008
Location: south africa
Posts: 325
Layman DPS 3 consistency problems

due to the fact that i hunt regularly, i have decided to upgrade to a electronic dispenser scale. two day ago i bought the DPS 3. now my problem is when the scale is finished dispensing , an alarms goes of signaling that the load is ready lets say 43grns. i then remove the load, but if i put that load back on the scale the reading differs. i make sure to warm up the scale every time. but i still have problems with consistency.

so to recap: i get one reading when the buzzers goes of 43grn, i then the remove the load using the small bucket, i wait 3-6seconds, when i replace the bucket the reading will differ, sometimes with as much as 1 grain. but most of the times with about .3-.8 of a grain.

any suggestions?
__________________
If youth is wasted on the young, then Africa is wasted on the Africans
lt dan is offline  
 
Page generated in 0.04633 seconds with 7 queries