View Single Post
Old June 2, 2011, 08:22 PM   #26
jd3020
Senior Member
 
Join Date: February 9, 2011
Location: mo
Posts: 175
Ok well after about fifteen min of taking a dryer sheet to the bottom of the powder bottle and and then doing the same to my mec #30 powder bushing the first load drop was 16.4 then the second was 16.8 and then from then on it varied from 16.6 to 16.8 with one instance being a 17.8 but I got that reading after I bumped my scale and got it out of wack. So I think it's safe to say my 30 bushing is throwing 16.6-16.8 grains. Now with this finding I might do that same thing with my 31 bushing and see if it dosent get back to that 17-17.2 range
jd3020 is offline  
 
Page generated in 0.04372 seconds with 7 queries