Thread: shimming molds?
View Single Post
Old May 25, 2011, 01:48 PM   #10
res45
Senior Member
 
Join Date: September 15, 2007
Posts: 553
If you have a slug from the bore any good machine shop will have a micrometer that can measure that.

You can do it yourself also by wrapping a know thickness of brass shim stock around the slug and take your measurement with your standard calipers or micrometer from the measurement you get subtract the thickness of the stock times 2 and you have the dia.

It comes in handy when your measuring those five grooves S & W handgun slugs.
res45 is offline  
 
Page generated in 0.04323 seconds with 7 queries