View Single Post
Old May 21, 2011, 03:32 PM   #15
dikko
Member
 
Join Date: May 20, 2011
Posts: 22
Guys, with respect, you are complicating a simple job. If you want to slug a barrel it is probably because you intend to shoot cast bullets through it. Cast bullets are usually two or three thousandths bigger than groove before sizing. Therefore, a pure lead bullet cast in that mould makes a perfect slug. I've slugged lots of barrels, all with that method. Takes five minutes. I wrote a little 11 page booklet with lots of photos about it, to publish on the internet, just hasn't gotten published yet.
dikko is offline  
 
Page generated in 0.03997 seconds with 7 queries