View Single Post
Old April 29, 2011, 12:03 PM   #22
engineermike
Junior member
 
Join Date: March 14, 2010
Location: Oklahaoma City
Posts: 538
Jay,
No I have not yet received an answer to my question. But after thinking about it if it did not come through in my question, I am just wondering if all 115, 124, 180 grain hollow point, flat point, and round nose bullets are the same length respectively within tolerance. I would assume that if they are not then the loading instructions for powder weights would never be right. I am just curious as to why Wookie's Measurements were so far apart for the same grain bullet.
engineermike is offline  
 
Page generated in 0.04976 seconds with 7 queries