View Single Post
Old April 29, 2011, 01:38 AM   #12
HiBC
Senior Member
 
Join Date: November 13, 2006
Posts: 3,663
I have modded a few cheap small drill presses.The problem they all have is a plastic depth stop that is flexible.re-create the plastic part in aluminum,there is one hole that should be bored,as I recall.Bandsaw is close enough for the rest.Then you have a positive stop.Put a Lyman or Forster fixture on a plate.Somehow I put an arbor on an RCBS 3 way cutter.Gave mine to my brother,he has the Dillon presses.Works good.Been a while back,it not here with me.
HiBC is offline  
 
Page generated in 0.04136 seconds with 7 queries