View Single Post
Old April 25, 2011, 06:58 PM   #6
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,340
static is likely the culprit ...and I use anti static dryer sheets ....and wipe the powder measure down inside and out until no particles of powder stick to the wall of the powder cannister .....and I put some dryer sheets into my powder storage cannister.

No more than 0.1 grain is acceptable on handgun loads.../ although you might have a little more leeway depeding on the powder you're using .../ but not much. Any decent powder measure ought to get you down to the 0.1 grain without a big problem.
BigJimP is offline  
 
Page generated in 0.04952 seconds with 7 queries