View Single Post
Old April 20, 2011, 02:15 AM   #12
Rangefinder
Senior Member
 
Join Date: August 4, 2005
Posts: 2,017
I'm gonna state that I didn't read all the way through, but guess what this is about---putting a check on a PB boolit...... I've done it, it's not a problem. It's a PITA, but not an issue.. Cut a disc slightly larger than boolit diameter, shove the boolit through a lee sizer point-down with the disc over the base, and there ya go. I wouldn't rely on long range accuracy,. BUT, it checks as non-check boolit just fine. So long as you aren't seating below the shoulder so it blows off, it should ride the bore all the way through and out just fine.
__________________
"Why is is called Common Sense when it seems so few actually possess it?"

Guns only have two enemies: Rust and Politicians.
Rangefinder is offline  
 
Page generated in 0.03995 seconds with 7 queries