View Single Post
Old April 19, 2011, 10:33 AM   #34
riche
Member
 
Join Date: April 10, 2011
Location: upstate new york near the adirondacks
Posts: 37
I use 2 balance beam scales,side by side, one is an Ohaus magnetic dampening, the other a redding oil dampening scale. When I'm setting up my powder measure, I check on one, then recheck on the other, that way I know I set the charge weights right on the scales, sometimes its hard to see the tiny marks. Anyways when they're both set up and agreeing with each other, I start filling empty cases, I weigh each charge, draw a charge from powder measure, dump in one scale, draw another charge, dump in other scale, by then first scale has stopped moving, if its good to go, I dump in empty case. Otherwise I add or remove until its level. I find its much quicker using the 2 scales, and each charge is accurately weighed. Works good for me.

Last edited by riche; April 19, 2011 at 05:04 PM.
riche is offline  
 
Page generated in 0.04236 seconds with 7 queries