View Single Post
Old April 4, 2011, 05:06 PM   #18
edward5759
Senior Member
 
Join Date: September 15, 2009
Location: Phoenix, AZ. 30 miles from water, two feet from Hell.
Posts: 354
Unclenick is correct !
All Dillon dies use the carbide expander in them, but I had one that was off center. Dillon replaced it with a smile
I still use light lanolin lube when sizing with carbide is not necessary but a lot nicer.
On bolt guns, I pull the firing pin assembly out and keep resizing brass until I get one that just starts to drag when closing. That is how I set individual die to a rifle.
Some time I use a surface grinder and make a washer for the die if its for more than one rifle.
edward5759
edward5759 is offline  
 
Page generated in 0.04001 seconds with 7 queries