View Single Post
Old April 4, 2011, 11:54 AM   #15
deepcore
Senior Member
 
Join Date: July 24, 2010
Posts: 364
Thanks.
Will do that.
Already have the brass not "passing" the chamber checking in my bolt gun slated for semi-auto duty (and will keep the brass separate for each).
I didn't get to check my notes this weekend...so about needing a small base die...
I will check the post-fired headspace (not sized yet) of rounds from my semi compare it the post-sized ones that are too long for my bolt..and if I cannot get them sized by a couple ticks smaller than then post-semi fired headspace measurement then I need a small base die?
I don't have a Wilson case gauge yet. Dumb question: Can you chamber check an AR/LR?
Also working on getting the Redding Competition shell holder set.

Last edited by deepcore; April 4, 2011 at 12:17 PM.
deepcore is offline  
 
Page generated in 0.04621 seconds with 7 queries