The Firing Line Forums - View Single Post - Full length sizer not sizing all brass the same

wncchester · April 2, 2011, 10:34 AM

" I noticed that 1 out of 10 pieces of brass will not wind up with the shoulder bumped back as far as the others and won't chamber in my bolt gun when I chamber check them."

It would help if you told us how much difference you are obtaining. ??

But, whatever, it's likely you will do fine by following Steve4102's suggestion.

April 2, 2011, 10:34 AM	#5
wncchester Senior Member Join Date: December 1, 2002 Posts: 2,700	" I noticed that 1 out of 10 pieces of brass will not wind up with the shoulder bumped back as far as the others and won't chamber in my bolt gun when I chamber check them." It would help if you told us how much difference you are obtaining. ?? But, whatever, it's likely you will do fine by following Steve4102's suggestion.