View Single Post
Old April 1, 2011, 06:20 PM   #17
Huskerguy
Senior Member
 
Join Date: March 28, 2009
Location: Kansas
Posts: 346
So does anyone know if my XDM 40 is fully supported? I have started loading the 40 after much careful reading. I purchased some brass and discovered I have some bulged brass. It has been sorted out and off to the side. I thought about picking up a Lee bulge buster to resize this brass but is that a good idea or not? I load towards the light side, nothing hot at all. I understand the concept of the brass thinning out in the bulged area, that makes sense.
Huskerguy is offline  
 
Page generated in 0.05040 seconds with 7 queries