View Single Post
Old April 1, 2011, 09:20 AM   #16
zeke
Senior Member
 
Join Date: November 17, 1999
Location: NW Wi
Posts: 389
Would advise to pay attention to the above warning. While i use once fired glock 40 brass, it is used in revolver with a fully supported chamber, and a semi with a "much more supported chamber than early/current glock".

If you hang on to your 45 acp brass through enough loadings, a buldge (wider than spec) can develop at the base that the normal resizing die does not reach. This is associated with the brass "shortening" after mulitple resizing, not neccessarily through over pressure loads. In a "tight" chamber this can cause difficulties.
zeke is offline  
 
Page generated in 0.04575 seconds with 7 queries