View Single Post
Old March 25, 2011, 08:33 PM   #1
Renfro
Junior Member
 
Join Date: March 8, 2011
Posts: 13
Bulge Buster Question??

I have recently order all of my new goodies to get started on reloading. One of the things i purchased was the Lee Bulge Buster. It says that it should not be used for 40 S&W Glock or similar guns that do not fully support the cartridge with the chamber.

I have a FNP 45 and have read that this gun doesn't support the entire cartridge and upon removal of the barrel I noticed that on the bottom where the feed ramp is that some of the cartridge is exposed.

Why would you not want to correct this problem with the cartridge if it was
bulged and why does Lee say not to.
Just curious if anyone is using this with a non-fully supported round.

Thanks in advance
Renfro is offline  
 
Page generated in 0.03673 seconds with 7 queries