View Single Post
Old March 20, 2011, 09:52 PM   #12
zxcvbob
Senior Member
 
Join Date: December 20, 2007
Location: S.E. Minnesota
Posts: 4,166
If you flatten the faces of the molds with a stone, you will screw them up by removing the vent lines that allow the air to escape. Just check for rough edges to the bullet cavities at the parting line. That's where they'll be.
__________________
"The only way to stop a bad guy with a gun is with a good guy with a gun"
zxcvbob is offline  
 
Page generated in 0.04554 seconds with 7 queries