View Single Post
Old February 4, 2011, 02:21 PM   #17
FtrPilot
Member
 
Join Date: September 4, 2010
Location: Woodstock, GA
Posts: 88
Quote:
The best way to properly set up your taper crimp die is first resize a casing and measure the mouth diameter with a set of calipers. Now take that empty casing and run it through the crimp die and measure again. The two measurements should be the same, or up to .002 smaller,less is more when it comes to taper crimping.
res45 - Excellent technique for setting the taper crimp die. Thanks.
FtrPilot is offline  
 
Page generated in 0.04538 seconds with 7 queries