View Single Post
Old February 1, 2011, 06:58 PM   #2
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,491
Just a light taper crimp is needed for the 9mm, enough to prevent the setback as you discovered. Turn the die in a little at a time until you start noticing the case mouth is slightly rounded in toward the bullet. Very slightly.

My CZ however refuses to run unless I put it through the Lee FCD and give it enough taper crimp to make the case mouth flush with the round. Otherwise it gets hung up when feeding.
chris in va is offline  
 
Page generated in 0.04795 seconds with 7 queries