View Single Post
Old January 17, 2011, 10:33 AM   #1
longfellow
Senior Member
 
Join Date: October 11, 2010
Location: Upstate NY
Posts: 133
As-cast diameter?

Can you folks post your as-cast diameters for your commercial molds; those that cast 44 caliber would be most useful but I suspect that if there is any trend among manufacturers, that it is fairly consistent among all of their pistol calibers - maybe not. Please also list the alloy that you are using as this is a partial reason for the diameter that you are getting. Also, I do appreciate all of your responses but unless you are using properly callibrated vernier (readings to .0001) micrometers and callipers, the results might not be as accurate as otherwise could be. It's pretty important and I've slipped up myself and found at arbitrary times that my mic's were not zero'ed and I had been using them for months. It happens.
Thanks.

Lyman - ???
RCBS - ???
SAECO -???
LEE - ???
longfellow is offline  
 
Page generated in 0.05288 seconds with 7 queries