View Single Post
Old January 13, 2011, 11:47 AM   #5
longfellow
Senior Member
 
Join Date: October 11, 2010
Location: Upstate NY
Posts: 133
sizing while seating

My dimensional study shows that with typical cast bullet dimensions and brass case wall thicknesses, my bullets and cases each give about a thousandth. Pulled bullets show that about half of the bullet's give comes back because of elasticity of the lead bullet so the net of this is that with typical dimensions that bullet should be comming out of the case only about a half a though under the sized dimension, or in your case .3575.
Something else is going on.
longfellow is offline  
 
Page generated in 0.04596 seconds with 7 queries