View Single Post
Old January 12, 2011, 05:12 PM   #6
Rifleman1776
Senior Member
 
Join Date: April 25, 2010
Location: Arkansas
Posts: 3,309
Looks like sewerman solved the problem.
It is a simple process.
An earlier response was, unfortunately, off the mark.
52828jt, you were lucky. Some of those import hammers were made with a cast steel that just wouldn't bend. The early TCs were like that. I know, been there, done that. Maybe with a welding torch it could have been done but not with a propane or MAPP.
Rifleman1776 is offline  
 
Page generated in 0.04809 seconds with 7 queries