View Single Post
Old January 12, 2011, 03:16 PM   #5
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,405
It's simple, all you need some off-set caps!

Seriously, your hammer may not need bending. Looking at your third pic, the hammer doesn't look to be installed even close to having it's mounting screw perpendicular to the bore! It seems your cocker is cock-eyed -- is the screw bent, misaligned, or what? With the hammer screw seemingly out of square, I can imagine all sorts of nasty consequences. How's the sear alignment? I'd address this assembly problem before firing-up the forge.
zippy13 is offline  
 
Page generated in 0.04482 seconds with 7 queries