View Single Post
Old January 2, 2011, 12:36 PM   #17
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,472
napp
Understand that we are addressing a Traditional as the OP has listed. Support materials would be slightly different when addressing an In-Line.

My short ball starter is and older Butler Creek. It has a built in bore guide, steel shaft and brass cup or end as well as wooden ball. I do not know if you can buy these anymore.

On Jags and other stuff you mentioned. most are made by the same manucfacture anyway. CVA is a good source but you certainly can buy these from countless sources.

I own two Range-Rods and these were purchased from TC. Try Traditions on a Range-Rod. Stay away from an all Fier glass rod,

Precision powder measure; Get the higher end TC, preferably, all brass.

By the way, add a brass bore guide to your list ....

Be Safe !!!
Pahoo is offline  
 
Page generated in 0.04923 seconds with 7 queries