View Single Post
Old December 30, 2010, 02:53 PM   #1
wjtank
Junior Member
 
Join Date: December 12, 2009
Posts: 6
professional gunsmith advice needed

I am in need of some advice from a professional gunsmith. I have a 12 gauge Ithaca SKB model 600 O/U shotgun, circa 1970, 28" barrels, 2 and 3/4" chambers. The bottom barrel has a bulge about 10 and 3/4 inches from the breech end. If you look inside the bottom barrel, you can see what looks like a fairly uniform ring where the bulge is located.

Specifically, I am asking if there is any possibility that the barrel(s) can be repaired. I have included a few pictures below.








Bill in GA

Last edited by wjtank; December 30, 2010 at 02:58 PM. Reason: forgot to include gauge
wjtank is offline  
 
Page generated in 0.04343 seconds with 7 queries