View Single Post
Old December 28, 2010, 10:50 AM   #3
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,652
I do not know, I do know making an effort to help is a mistake, but, there a few things that can not or should not be done on a Japanese rifle, Most have to do with the safety and rotating the bolt. I would suggest holding the trigger down while attempting to rotate the bolt, then I would suggest removing the action from the stock and then removing the trigger group. The safety can be installed incorrectly by jumping/ force fitting, the problem creates a rub-ix cube puzzle because the safety when installed correctly aligns the bolt assembly.



There is a notch on the bottom of the bolt that aligns with a the top of the trigger, when the bolt is in a particular position or configuration the handle can not be raised.



F. Guffey
F. Guffey is offline  
 
Page generated in 0.05493 seconds with 7 queries