View Single Post
Old December 27, 2010, 10:33 AM   #2
Slopemeno
Senior Member
 
Join Date: January 19, 2007
Posts: 2,328
Difficult, not impossible.

I do a bit of composites work in my other hobby, and kevlar isn't all that difficult to cut (or break, for that matter). Cutting with a saw might get you a ball-of-yarn effect, but alternatives like a dremel cut-off-wheel should get you through without too much trouble.

What were your plans for finishing the raw end of the stock, once you've shortened it?
Slopemeno is offline  
 
Page generated in 0.05151 seconds with 7 queries