View Single Post
Old December 26, 2010, 08:48 PM   #7
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
The hammer drift pin doesn't want to budge. Is there a chance that it was peened over and I just have to give it more of a rap. Perhaps penetrating oil is needed but I don't see how it would even get in there. Do the heads of the pins sometimes have to be sheared off with a sharp chissel? I suppose as long as I have a replacemenet pin, I can drill it out.
TheKlawMan is offline  
 
Page generated in 0.03887 seconds with 7 queries