Thread: seater plug
View Single Post
Old December 25, 2010, 12:01 AM   #3
reloader28
Senior Member
 
Join Date: October 13, 2009
Location: nw wyoming
Posts: 925
I have the same mold and I dont remember if I did it to this one or not, but I have taken the seater plug out of some of my dies and rounded off the inside just a touch with a Dremal. Just a little bit off the sharp edge is usually all it takes to get rid of the marks.

I've had to do this with a couple top punches too.
reloader28 is offline  
 
Page generated in 0.04271 seconds with 7 queries