View Single Post
Old December 22, 2010, 06:32 PM   #3
bcrash15
Senior Member
 
Join Date: April 7, 2007
Posts: 441
Good idea. For a quick check just a second ago I removed the bolt, forced a round under the extractor and reinserted the whole assembly, cartridge and all, and it seemed to chamber and extract/eject just fine. I will pop that extractor off and see if there are any obvious burr or nicking issues that might be grabbing. In doing research, I found there are a lot of problems that are apparently fixed with a new extractor, but they are usually weak or lack of ejection.
bcrash15 is offline  
 
Page generated in 0.04329 seconds with 7 queries