View Single Post
Old December 22, 2010, 06:30 AM   #2
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,871
I would remove the extractor from the bolt and chamber a test round. This would be a good time to check the head space. If the round chambers then take a look at the extractor and stone any sharp edges that may be hanging up on the brass.

The Yugo M24/47 is 8mm but it could possibly have been re-barreled in another caliber.
madcratebuilder is offline  
 
Page generated in 0.04181 seconds with 7 queries