View Single Post
Old December 21, 2010, 12:35 AM   #7
chris in va
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,120
These were "dipped" in LLA (Lee Liquid Alox),
If you want a tumble lube that dries in less than an hour without any tackiness, get some Johnsons Paste Wax in the can. Melt some into a cup, mix in about 25% mineral spirits to thin it out, use as tumble lube. Much easier on your sizing/seating dies too.

It tends to solidify once cooled off, so it needs to be melted again, just run the container under hot water for a couple minutes.
chris in va is offline  
Page generated in 0.03214 seconds with 7 queries