View Single Post
Old December 18, 2010, 01:25 AM   #2
triggerman770
Senior Member
 
Join Date: August 9, 2009
Location: Metro Atlanta Area
Posts: 125
Sheared ejector leg

there is a cross pin in the frame below the rail that needs to be drifted out and then the leg should come out unless an adhesive like loctite was used.
the leg should have a notch cut in it to allow the pin to arrest the leg, you can use another pin to push up and get the leg above the rail surface.
__________________
Small Arms Restoration, Inc.
smallarmsrestoration.net
Proud member of Georgia Carry.org
www.georgiacarry.org
triggerman770 is offline  
 
Page generated in 0.04878 seconds with 7 queries