View Single Post
Old December 11, 2010, 04:05 PM   #1
1chig
Senior Member
 
Join Date: October 31, 2009
Location: central missouri
Posts: 237
ok guys here i go

please bare with me, i may be a little long winded. Anyway i am wanting to get started on casting bullets for a .38 special revolver with a 2 in. barrel. I have been reloading for about three years, mostly rifle but some 9mm & .38. I have also been melting leead for 10 years or more, making my own jigs for fishing. I have lots of lead and a lee 10lb bottom pour pot. I understand the basics. such as melt lead poor into bullet mold, remove size and lube then load. My questions are 1. What specificly mold to get, probably 2 cavity that poors round head 125 grn. or so. 2. lubing and sizing, what should i get? 3. where do i get my load data for cast bullets ? I have read the sticky and also abc's of reloading, very helpful , but i still have these questions. Sorry for being a pita. I am very excited about this and getting started. I would like to order what i need tomorrow. If i have left anything out please let me know. I want to start out small and see how it goes, meaning i dont want to spend a 100.00 on a bullet mold i also will probably order everything from midway. I will only be shooting target and though i shoot reguarly i dont shoot a lot at a time. So i will be low volume. So there it is any takers? thanks
__________________
those who anger you are those who control you!!!!
1chig is offline  
 
Page generated in 0.04465 seconds with 7 queries