View Single Post
Old December 2, 2010, 10:01 PM   #9
napp
Senior Member
 
Join Date: November 30, 2010
Location: Georgia
Posts: 152
Good point about the transportability, Doc. I'll have to tinker with it once I have the press in hand. My initial thoughts are to mount it longitudinally on a 2x6 or 2x8 with a length of 18", or so. I'm also thinking that I can run bolts up through the board with the heads countersunk and epoxied in the bottom. ie: create studs in the board and attach the press with wing nuts for ease in assembly/disassembly during transport.
napp is offline  
 
Page generated in 0.05481 seconds with 7 queries