View Single Post
Old October 11, 2010, 09:53 PM   #9
okiefarmer
Senior Member
 
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
Something I have done on these six holers for years, and it's worked for me, as I have micced them and they come out pretty dead on is when I close them with the left hand, I have the little sprue mallet that I use on most of the "other" moulds and just lightly tap the bottom of the mould halves while closing. This seems to let the halves close a bit better on those line-up pins all the way. I reject dang few this way.

My two pesos
okiefarmer is offline  
 
Page generated in 0.05353 seconds with 7 queries