View Single Post
Old October 10, 2010, 04:23 PM   #3
bubbadawg59
Junior Member
 
Join Date: October 10, 2010
Location: siouxland
Posts: 6
the mold is a lee 45 swc tumble lube 6 cav .im using a lee production pot20 pounder with the heat seating set on 7.and yes the mold has been smoked and i always lube my pins and hinges with a smeer of lube. my casting rate is about as fast as i can clear the spru off and empte the mold with out it getting overheated. im just air cooling the slugs
bubbadawg59 is offline  
 
Page generated in 0.04057 seconds with 7 queries