Thread: shallow
View Single Post
Old October 8, 2010, 01:57 PM   #1
salvadore
Senior Member
 
Join Date: January 1, 2007
Location: Idaho
Posts: 1,864
shallow

I purchased a Lee 6 cavity 44 rn 240...ummm250,,,gr mold and cast up a few to try em out. my normal unsized lube method didn't work well so I ran them thru my lyman lubersizer, which is a good lubersizer if you don't plan on doing much shooting. My concern is the niggardly amount of lube the grooves accept. I'm use to lyman's older designs that accerpt lotsa lube. Has anyone found this to be a problem? I also have a lee 8mm mold I haven't tried yet and it also has teensy (technical term) lube grooves, the truncated .45 230 gr mold seems to be okee pokee, the groove isnt deep but is quite a bit wider. anyone anyone?
salvadore is offline  
 
Page generated in 0.04521 seconds with 7 queries